Effect of Mould and Melt Temperature on the Properties of Styrene Acrylonitrile Moulded Parts

Authors

  • Cahyo Budiantoro University of Muhammadiyah Yogyakarta
  • Adi Nugroho Politeknik Akademik Teknik Mesin Industri

DOI:

https://doi.org/10.22219/jemmme.v3i1.5711

Abstract

The quality of injection moulded parts can be influenced by processing parameters. The effect of mould temperature and melt temperature on the weight and shrinkage of Styrene Acrylonitrile moulded part was observed in this research. It was found that by increasing mold temperatures at constant melt temperature and injection speed, the weight of the part decreased and the shrinkage value slightly decreased. On the other hand, by increasing melt temperature at constant mold temperature and injection speed, the part weight increased. Both mold temperature and melt temperature gave only a small effect because the temperature difference was not too large.

Downloads

Download data is not yet available.

References

Kurt, Mustafa., Kaynak, Yusuf., Kamber, Omer., Influence of molding conditions on the shrinkage and roundness of injection molded parts. The International Journal of Advanced Manufacturing Technology. 2010;46: 571 - 578.

K. M. B. Jansen., D. J. Van Dijk, and M. H. Husselman., Effect of Processing Conditions on Shrinkage in Injection Molding. Polymer Engineering And Science. 1998, Vol. 38, No. 5

Alias Mohd., Ainul Ayunie Roslan., Nor Bahiyah Baba., Effect of Injection Molding Parameters on Recycled ABS (r-ABS) Mechanical Properties. Indian Journal of Science and Technology, Vol 9(9)

Nagahanumaiah., B. Ravi., Effects of injection molding parameters on shrinkage and weight of plastic part produced by DMLS mold. Rapid Prototyping Journal. 2009., Vol 15(3):179-186

Parvin Shokri., Naresh Bhatnagar., Effect of Packing Pressure and Mold Temperature on Fiber Orientation in Injection Molding Of Reinforced Plastics. The 8th International Conference on Flow Processes in Composite Materials (FPCM8). Douai, FRANCE. 2006; 409 - 416.

J. M. Fischer, Handbook of Molded Part Shrinkage and Warpage, Plastic Design Library / William Andrew / Inc., USA, 2002

Downloads

Published

2018-06-30

How to Cite

Budiantoro, C., & Nugroho, A. (2018). Effect of Mould and Melt Temperature on the Properties of Styrene Acrylonitrile Moulded Parts. Journal of Energy, Mechanical, Material, and Manufacturing Engineering, 3(1), 7–14. https://doi.org/10.22219/jemmme.v3i1.5711

Issue

Vol. 3 No. 1 (2018)

Section

Articles

License

Authors who publish with this journal agree to the following terms:

  1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution-NonCommercial 4.0 International License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
  2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
  3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).

Creative Commons License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.