Kesetimbangan Energi Termal Dan Efisiensi Transient Pengering Aliran Alami Memanfaatkan Kombinasi Dua Energi

Authors

  • I Gusti Agung Kade Suriadi
  • Made Ricki Murti

DOI:

https://doi.org/10.22219/JTIUMM.Vol12.No1.34-40

Keywords:

utilization, natural flow condition, the balance of thermal energy, the efficiency of the dryer system

Abstract

The energy used as a dryer is usually only a single type of energy. In this case, study is conducted on the natural flow
dryer system by using the chimney. This combination of energy utilization of solar energy and biomass that can be used simultaneously or one turns in accordance with the needs or circumstances. It has been tested against a dryer prototype by performing measurements on the temperature of the inlet air and exit on biomass furnace, the temperature of the inlet air and exit on the solar collector, the temperature of inlet air and exit on the drying chamber, the water content of dried material, the temperature of dried material, the surface temperature of inside and outside of wall on drying chamber, and the intensity of solar radiation. Data were collected at an interval of 30 minutes and do the processing of such data. Next made in a graphical form of thermal energy balance and system efficiency versus the time. Results obtained that: the drying time was 7.5 hours. Thermal energy balance versus the time found that the increase of energy losses lead to useful energy reduction system.

Downloads

Download data is not yet available.

Downloads

Published

03/30/2012

How to Cite

Kade Suriadi, I. G. A., & Ricki Murti, M. (2012). Kesetimbangan Energi Termal Dan Efisiensi Transient Pengering Aliran Alami Memanfaatkan Kombinasi Dua Energi. Jurnal Teknik Industri, 12(1), 34–40. https://doi.org/10.22219/JTIUMM.Vol12.No1.34-40

Issue

Section

Article